Here comes some logs.
First of all, I did reinstall the drivers for the Twinhan DVB-T 3030 cards and did a clean install of the TV server (SVN Rev20143).
I have the following TV cards listed in the TV Server:
Card1) DVB-S DTV-DVBS 878 Digital Tuner Filter, Prio 4 (Twinhan BDA Driver 1.2.3.8)
Card2) DVB-T DTV-DVB Mantis1 DVBT BDA Receiver, Prio 3 (Mantis BDA Driver 1.1.0.400)
Card3) DVB-T DTV-DVB Mantis2 DVBT BDA Receiver, Prio 2 (Mantis BDA Driver 1.1.0.400)
All tests are done from within the TV Server configuration, I will try to describe what I did step by step.
1) Scan for channels on Card3. The cards tunes to the different transponders but the result is "Nothing found".
2) Scan for channels on Card2. Channels are found ok.
3a) Manual Control -> Start timeshifting on a channel. Card2 starts timeshifting ok.
3b) Scan for channels on Card3. The cards tunes to the different transponders but the result is "No signal" this time.
3c) Stop timeshifting
4) Map all channels found in step 2 to Card3. Remove one channel (TV4 in this case) from Card2.
5) Start timeshifting a channel on transponder not containing the channel in step 4 (SVT1 in this case). Card2 starts timeshifting ok.
6) Start timeshifting on the channel removed from Card2 in step 4. According to the logs Card3 is chosen correctly, but the result is unknown error.
I checked in GraphEdit for the different filter and it seems that different BDA filters are present both for Card2 and Card3. But with different device id's.
Please take a closer look at the selection algorithm for selection the BDA capture device. |