HAUPPAGE 500 MCE - no signal detected - yet all ok

tfd · 2006-04-18, 20:48

very annoying but card works fine. Upon chaning channels in myTV MP responds with a "no signal detected" popup although there is signal

this started with SVN from 16-APR

gadu^ · 2006-04-19, 09:34

i've noticed that whenever i had updated with a new SVN (from what date i don't remember exactly, but the lastest ones) i've had go to configuration and change from cable to antenna, press ok, enter configuration again and then change back to cable again. Then all channels got back. Once i had to rescan all channels as well...

And yes, i do backup of the channel list everytime i update with a new SVN and no it did not help to restore the backup.

BigCharlie · 2006-12-20, 08:14

I was just troubleshooting the same problem...thanks for your post, it prompted me to look in the right spot.

Thanks!

2006-04-18, 20:48	#1 (permalink)
tfd Portal Member Join Date: Mar 2006 Posts: 36 Thanks: 0 Thanked 0 Times in 0 Posts	HAUPPAGE 500 MCE - no signal detected - yet all ok very annoying but card works fine. Upon chaning channels in myTV MP responds with a "no signal detected" popup although there is signal this started with SVN from 16-APR

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
KNC 1 DVB-C / cannot tune channels	lutz	General Support	15	2006-10-01 12:04
no channels with KNC1 c+	oli2011	General Support	1	2006-08-15 11:40
Nova-t USB2	sim1964	General Support	2	2006-06-24 11:03
Hauppauge HVR-1300: Problem with digital/analouge channel	Bev83	General Support	9	2006-06-01 13:39

2006-04-19, 09:34	#2 (permalink)
gadu^ Portal Member Join Date: May 2005 Posts: 27 Thanks: 0 Thanked 0 Times in 0 Posts	i've noticed that whenever i had updated with a new SVN (from what date i don't remember exactly, but the lastest ones) i've had go to configuration and change from cable to antenna, press ok, enter configuration again and then change back to cable again. Then all channels got back. Once i had to rescan all channels as well... And yes, i do backup of the channel list everytime i update with a new SVN and no it did not help to restore the backup.

2006-12-20, 08:14	#3 (permalink)
BigCharlie Portal User Join Date: Dec 2006 Age: 33 Posts: 3 Thanks: 0 Thanked 0 Times in 0 Posts Country:	I was just troubleshooting the same problem...thanks for your post, it prompted me to look in the right spot. Thanks!