Power Scheduler not waking up for scheduled recordings - Page 2

pipeme · 2007-07-05, 05:07

OK

I did an OS reinstall and installed RC1 and PS now works fine. Next I will install MST and see if that stops PS from waking up my PC.

NoMercy · 2007-07-20, 18:25

Hi,

I had the same problems with wake up, too.

From fresh installation (OS=XPMCE and MP=0.2.3.0RC1+SVN) all worked fine.
After some config changes in TVE3 I had the same problem again:
- manual suspend worked, then wake up worked
- going to standby with Power Scheduler, no wake up

I've tried to figure out what my config changes in TVE3 were and found the following:
- if I don't set the option "reinitialize MP (and tunercard) after standby" (sorry don't know how this option is called in english, 'cause using a german MP) everyting works fine for me
- if I set this option this above-named strange behavior occurs again

I'm not sure if this is typical for my hardware config, but maybe is a hint for you.

Greetz,
Mike

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
PVR Scheduler - Power Scheduler. Rund um Standby, Hibernate, Taskplaner, Girder	HiveGuard	Media Portal - Allgemeines	8	2007-02-25 12:33
Power scheduler not waking pc	luke16	General Support	3	2007-01-15 08:29
power scheduler	stadtkind	Plugins/Erweiterungen	4	2006-08-16 14:08
is there problems waking for recordings with 0.2?	zombiepig	General Support	2	2006-07-17 15:10
EPG: Scheduled Recordings not marked as scheduled	infinityloop	0.2.0.0 Release Candidate 1 CVS Bugs	0	2005-12-27 12:08

2007-07-05, 05:07	#11 (permalink)
pipeme Portal Member Join Date: May 2007 Posts: 44 Thanks: 0 Thanked 0 Times in 0 Posts Country:	OK I did an OS reinstall and installed RC1 and PS now works fine. Next I will install MST and see if that stops PS from waking up my PC.

2007-07-20, 18:25	#12 (permalink)
NoMercy Portal Member Join Date: Jun 2007 Posts: 5 Thanks: 0 Thanked 0 Times in 0 Posts Country:	Hi, I had the same problems with wake up, too. From fresh installation (OS=XPMCE and MP=0.2.3.0RC1+SVN) all worked fine. After some config changes in TVE3 I had the same problem again: - manual suspend worked, then wake up worked - going to standby with Power Scheduler, no wake up I've tried to figure out what my config changes in TVE3 were and found the following: - if I don't set the option "reinitialize MP (and tunercard) after standby" (sorry don't know how this option is called in english, 'cause using a german MP) everyting works fine for me - if I set this option this above-named strange behavior occurs again I'm not sure if this is typical for my hardware config, but maybe is a hint for you. Greetz, Mike