| |||||||
| General Support Post problems you have when using MediaPortal, or pre installation questions in here. |
![]() |
| | Thread Tools | Display Modes |
| | #1 (permalink) |
| Portal Member | I use an MCE remote, all set to load MP when the green button is pressed. I have the pc power button on the remote put the pc into standby (not hibernate). When the button is pressed again the pc wakes back up. Is it possible to have MP autoload from a wake up like you can on a normal start up? Not bothered about it being in the same state, ie: halfway through a movie, just load up regularly I have searched the forums but not found what I was looking for. Thanks for any info you may give. |
| | |
| |
| | #2 (permalink) | |
| Portal Tester Join Date: Feb 2005 Location: Melbourne
Posts: 1,888
Thanks: 4
Thanked 13 Times in 13 Posts
Country: | Quote:
![]() | |
| | |
![]() |
| Bookmarks |
| Tags |
| mode, stand |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| TV Scheduler | ca n vt | Codecs, External Players | 12 | 2008-04-26 10:01 |
| Long TV shows won't search | ca n vt | Codecs, External Players | 20 | 2006-09-04 02:08 |
| TV-card is detected in setup but not in MP itself | TL@ | Installation, configuration support | 4 | 2006-07-12 16:19 |
| MP Crashing Compro T300 - Australia | Coolman70 | Installation, configuration support | 2 | 2006-07-06 05:53 |
| Screen | Satansbraten | The old Bugreport Forum | 2 | 2006-07-04 21:23 |