Completed My single-seat complete setup (1 Viewer)

[McFly]

Here is my first HTPC build. It's quite old (about 2 years), but still valid and fast. The TV is quite new (see specs)…


HTPC:
Gigabyte GA-EP45-DS5 mobo
Intel Core 2 DUO E8400 3.0 GHz
Scythe Ninja Mini cpu cooler
OCZ Kit 4Gb DDR2 1066Mhz
1 x WD Green 2TB
1 x WD Green 640GB
Gigabyte HD5450 1GB passive video card
Skystar HD2 DVB-S2 sat card
Terratec Cynergy usb xxs DVB-T stick
Noctua NF-P14 fan
Scythe 12mm fan
Enermax Modu82+ 525W
Antec Fusion Remote Max case

Software:
Windows 7 64Bit Ultimate
MediaPortal 1.2 beta
SAF 6.0 codecs

TV:
Sony 55NX810 with 3D glasses
(on top there's a Logitech Webcam, on the bottom of tv there are the wii sensor bar and the Sony signal emitter for 3D glasses

AVR:
Yamaha RX-V3067 (aka A3000)

5.1 Speakers:
orbaudio Mod2 satellites
Mosscade Titan 4.1 active subwoofer

Console:
Nintendo Wii
Sony PS3 slim

Input devices:
Logtech Mediaboard Pro (for both PS3 and HTPC)
Logitech Harmony One remote

Furniture:
iron custom made


[URL=http://imageshack.us/photo/my-images/339/02062011img6585.jpg/] [/URL]

 

[DaFixer]

Very nice and clean
And the furniture looks very good

 

[Peter2]

Nice setup and I like the DIY furniture a lot because of being so minimalistic and of course being self-made.

It's a pity that the bending because of the weight was not considered; a simple tube or L-profile or even just a strip perpendicular on the sheet would have prevented that.

 

[McFly]

Thank you guys.
Peter2: the furniture it's not bended, it's my camera wide angle lens that created the barrel effect (look at the TV, it's "bended" too)
the furniture is much.... much heavier than what it's contained in it.

 

[Peter2]

luckily your tv is like that because of the camera lens.

I was so focused on the furniture because I'm also looking for a clean, simple solution which I have not found yet in a store.
Now I even see that the lines of your floor are not straight... ouf! Am happy for you that I see it wrong!

Because of being open at the back, I thought that the weight of the amplifier and you HTPC was a little bit underestimated in the design.
Where is the outer sheet welded, since it has all round edges?

 

[RubenD]

Nice cabinet for your system!