Reply to thread

Message

<blockquote data-quote="logifuse" data-source="post: 821353" data-attributes="member: 110442">Hi edterbak,Thanks very much for your reply. Aero is enabled. I don't have the overclocking section in my CCC, but I ran GPU-Z &amp; the utilization is in that 60-70% range you mentioned.It didn't seem to matter where the deinterlacing setting was set to, so that doesn't look like the problem. 720p channels show the same results too.I also ran some MPC-HC tests (using the graphs/stats you can access with the MS DirectX SDK installed) &amp; the results were pretty much the same.I'm running Win 7 SP1 64 bit, yet the versions of these Arctic systems supplied with Windows pre-installed (mine was barebones) have 32 bit &amp; Arctic only have 32 bit drivers on their site (they're just 32 bit versions of drivers from the various component suppliers such as ATI, Realtek, Intel, etc., nothing actually system specific). I suppose I'll do a fresh install of 32 bit &amp; go from there.</blockquote>

[QUOTE="logifuse, post: 821353, member: 110442"] Hi edterbak, Thanks very much for your reply. Aero is enabled. I don't have the overclocking section in my CCC, but I ran GPU-Z & the utilization is in that 60-70% range you mentioned. It didn't seem to matter where the deinterlacing setting was set to, so that doesn't look like the problem. 720p channels show the same results too. I also ran some MPC-HC tests (using the graphs/stats you can access with the MS DirectX SDK installed) & the results were pretty much the same. I'm running Win 7 SP1 64 bit, yet the versions of these Arctic systems supplied with Windows pre-installed (mine was barebones) have 32 bit & Arctic only have 32 bit drivers on their site (they're just 32 bit versions of drivers from the various component suppliers such as ATI, Realtek, Intel, etc., nothing actually system specific). I suppose I'll do a fresh install of 32 bit & go from there. [/QUOTE]

Verification