A few channels freezing (1 Viewer)

[mtjoernelund]

TV-Server Version: 1.0.0 RC4
MediaPortal Version: 1.0.0 RC4
MediaPortal Skin: Blue3Wide, StreamedMP
Windows Version: Vista Ultimate
CPU Type: Phenmon 9500
HDD: Seagate 500Gb
Memory: 2 GB
Motherboard: Gigabyte GA-MA78-S2H
Video Card: Onboard
Video Card Driver: 8.9
Sound Card: onboard
Sound Card AC3:
Sound Card Driver:
1. TV Card: Floppy DTV
1. TV Card Type: DVB-C
1. TV Card Driver: Latest
2. TV Card:
2. TV Card Type:
2. TV Card Driver:
3. TV Card:
3. TV Card Type:
3. TV Card Driver:
4. TV Card:
4. TV Card Type:
4. TV Card Driver:
MPEG2 Video Codec: PoverDVD 8
MPEG2 Audio Codec: ffdshow
h.264 Video Codec: PowerDVD 8
Satelite/CableTV Provider: YouSee DK
HTPC Case: OrigenAE
Cooling:
Power Supply:
Remote:
TV:
TV - HTPC Connection:

I have a very fine working MP setup - however a few of my tv-channels are not working.

The problem is that when I tune to those channels I get a frozen picture and no sound. Sometimes the picture will play, but still there is no sound. This goes for the same four channels and I cannot find any common grunds between those four channels. Changing back to any other channel and MP plays just fine.

I have tried both tuning the channels in preview and starting manual timeshift in TV-server config screen. When starting manual timeshift the channels seem to tune just fine and no errors seem to ocure. Trying to preview in the channellist produce same result as inside MP.

Does anybody have a suggestion on where I could look for the problems, 'cause I have run out of ideas...

 

[Eeyore]

upload your logs, but it sounds like you may have a weak signal on those channels

 

[mtjoernelund]

I will try making a set of logs and adding them to the post. Was just thinking that someone might have a suggestion that I had not thought of.

However I do not think it is a signal quality matter. I am using high quality signal cables and splitter. My cable provider has been out and measured my signal and it is in the higher end strengthwise. And finally I have tried adding a signal strengthener (I am not sure that is the right word for it but hopefully you know what I mean) and that did not change the behavior.

But as stated, I will make a set og logs later today and post them here.

 

[mtjoernelund]

Now with logs attached. Hope someone more wise than me can find out some more.

View attachment 38173

 

[mtjoernelund]

#bump#

Nobody that can helt me with some hints on this one?