- March 30, 2008
- 33
- 1
- Home Country
-
Germany
Hi!
I have a little problem - when I press Volume Up or Down on the remote control of my amplifier, it seems to be the same signal as the "0" (zero) button on my Hauppauge control which I use for MP.
It is quite annoying if you watch a movie and it starts again from the beginning just because someone increases or decreases the volume...
My question is now whether it is possible to switch off especially the interpretation of the "0" signal in Media Portal?
Thanks in advance for all your help.
Baldur
I have a little problem - when I press Volume Up or Down on the remote control of my amplifier, it seems to be the same signal as the "0" (zero) button on my Hauppauge control which I use for MP.
It is quite annoying if you watch a movie and it starts again from the beginning just because someone increases or decreases the volume...
My question is now whether it is possible to switch off especially the interpretation of the "0" signal in Media Portal?
Thanks in advance for all your help.
Baldur