ATI PCI Card (1 Viewer)
- Thread starter kevin87
- Start date
Users who are viewing this thread
Similar threads
Actually I solved this myself. I did have the correct driver (it was the only one which would work). But on the drivers download page, there was an additional item called "TBS6281se V2 Change Mode Tool". There was zero documentation to accompany this. I downloaded it and ran it. It is a tool to detect the current run state of both...
Actually I solved this myself. I did have the correct driver (it was the only one which would work). But on the drivers download...
My previous TBS PCI-E card failed, so I bought another one. The model I chose is the TBS 6181-SE, which can be seen on Amazon here...
MP1
MP2
1.38
Running TVService as "NT Service\TVService" or "Local Service" not working anymore since Windows September 2025 updates
DE
Reading through your code, I can see it's more than a couple steps above my paygrade. :cry:
Reading through your code, I can see it's more than a couple steps above my paygrade. :cry:
I used to run the TVService under the "NT Service\TVService" account to follow least privileges principal (not exposing my whole...
Hi
This is a general question about OnX.
I have been using the TvWishList plugin for a while and have recently updated (update install) from MP 1.36 x86 to 1.37 x86 and found there seemed to be no Onx menu in the TV guide. I then configured the onx.presets.xml file like I would normally do with updates or fresh installs, but still...
Hi
This is a general question about OnX.
I have been using the TvWishList plugin for a while and have recently updated (update...
Hi
This is a general question about OnX.
I have been using the TvWishList plugin for a while and have recently updated (update...
I haven't tested it.
I use MP1, but sometimes I try to help with MP2 :).
I haven't tested it.
I use MP1, but sometimes I try to help with MP2 :).
This happened immediately after my Windows 11 x64 monthly update for November. The update included also cumulative update to .NET...
Can anyone tell me the step-by-step procedure for bringing up a second channel in pip mode? I can only do it sometimes, after many tries, and it’s not clear what I am doing that makes it work on those occasions when it does. Cannot find guidance on the site.
Thanks, N.
Again, if anyone knows how to do this, would be much...
Can anyone tell me the step-by-step procedure for bringing up a second channel in pip mode? I can only do it sometimes, after many...
Can anyone tell me the step-by-step procedure for bringing up a second channel in pip mode? I can only do it sometimes, after many...