Blasting test issue (1 Viewer)

russ_kz

Portal Member
September 24, 2009
9
0
Gents,

My MCE has learnt succesfully (Translator from IRSS 1.0.4.1) IR commands from AV receiver remote. However during the test blaster is blinking but AV receiver does not respond as expected (1 successful attempt from 20), trying to hold the blaster as close as possible to my AV receiver, but with no luck with getting better response.

Could you please advise what might be the cause?

Many thanks
 

rekenaar

Retired Team Member
  • Premium Supporter
  • December 17, 2006
    4,421
    805
    Home Country
    South Africa South Africa
    Hi there :)

    as close as possible
    Are they right next to each other? In other words touching?

    Some of these blasters are not very strong and positioning is of the essence.
     

    russ_kz

    Portal Member
    September 24, 2009
    9
    0
    I am using one blaster (port 1) for this and trying to position densely to window of AV receiver where IR reader as I assume. You know there is darken glass on front size of AV receiver, so it is pretty difficult to find out the exact place of IR reader.
     

    Users who are viewing this thread

    Top Bottom