Reply to thread

Message

<blockquote data-quote="Heinra" data-source="post: 828909" data-attributes="member: 102384">AW: BluRay with MP and PowerDVD:sorry:Sorry for my german question.i hope you understand my denglish.i have set up my Htpc new, with new Board,CPU and SSD and HD-Starter installed new Meo 1.2.2 and HD-Starter discribed in 1st post.Everything looks good but if I closed PDVD MePo do not switch back to 50 Hz.ForExample:I start BluRay- MePo close - Screen switch from 1280*720 50 Hz to 1080p 24 Hz- PDVD starts- Video finished PDVD closed-MePo starts again-&nbsp; but do not restore 50HZIn ATI/AMD CCC I have creat the HotKeys (CTRL+Shift+4) and (CTRL+Shift+5) for the different resolution and refreshrates I am using.Must I change somethingin the Starter.ini ?In my old Setup with Mepo 1.0 and PDVD 9 (new PDVD 11-MePo 1.2.2) everything was ok.THX for helping me.Best regards, Rainer</blockquote>

[QUOTE="Heinra, post: 828909, member: 102384"] [b]AW: BluRay with MP and PowerDVD[/b] :sorry: Sorry for my german question. i hope you understand my denglish. i have set up my Htpc new, with new Board,CPU and SSD and HD-Starter installed new Meo 1.2.2 and HD-Starter discribed in 1st post.Everything looks good but if I closed PDVD MePo do not switch back to 50 Hz. ForExample: I start BluRay- MePo close - Screen switch from 1280*720 50 Hz to 1080p 24 Hz- PDVD starts- Video finished PDVD closed- MePo starts again- but do not restore 50HZ In ATI/AMD CCC I have creat the HotKeys (CTRL+Shift+4) and (CTRL+Shift+5) for the different resolution and refreshrates I am using. Must I change somethingin the Starter.ini ? In my old Setup with Mepo 1.0 and PDVD 9 (new PDVD 11-MePo 1.2.2) everything was ok. THX for helping me. Best regards, Rainer [/QUOTE]

Verification