cannot upgrade from existing svn build (1 Viewer)
- Thread starter marius1
- Start date
United States of America
Users who are viewing this thread
Similar threads
Ran into this problem following an otherwise sucessful upgrade from MP 1.34 x64 to MP 1.35 x64 the CEC Remote plugin which I use just to control volume and standby, will no longer put my devices (TV & AVR) to sleep when the HTPC is put in standby. Also when I wake up the HTPC MP closes or crashes (not sure which) as per the example in...
Ran into this problem following an otherwise sucessful upgrade from MP 1.34 x64 to MP 1.35 x64 the CEC Remote plugin which I use...
Ran into this problem following an otherwise sucessful upgrade from MP 1.34 x64 to MP 1.35 x64 the CEC Remote plugin which I use...
When my AVR bit the dust recently I took the opportunity to upgrade my projector to an LS11000 to gain 4K. Install went fine until I switched to my HTPC which is my primary source. When I switch to the HTPC the screen goes blank for a long time and then I have sound, no picture, and in the lower left hand corner:
"Source: HDMI 1
Not...
When my AVR bit the dust recently I took the opportunity to upgrade my projector to an LS11000 to gain 4K. Install went fine until...
When my AVR bit the dust recently I took the opportunity to upgrade my projector to an LS11000 to gain 4K. Install went fine until...
It should work, but the error is in something else, but it is not yet clear what.
It should work, but the error is in something else, but it is not yet clear what.
I have MP1 TV Server 1.30 installed on Windows Server 2012R2 (with some bits added for tuner support). MP Server versions have...
Ok, so perhaps a solution, but not the "right" solution. On the client, within media portal configuration, under TV settings, advanced options, I switched to UNC paths instead of the default RSS, and it's working very well. Sure I had to figure out the paths, but no big deal.
Maybe helpful for someone in the future. Thanks for the...
Ok, so perhaps a solution, but not the "right" solution. On the client, within media portal configuration, under TV settings...
Hi folks. I have an issue with a new install/integration into my mediaportal system. I have a “mediaportal server” which has the TV...
- Sticky
Upgrade install on MP 1.36 x64 proceeded without issue, everything I have tried so far is working and looking very good.
Many Thanks(y):)
Upgrade install on MP 1.36 x64 proceeded without issue, everything I have tried so far is working and looking very good.
Many...
Pre Releases are provided as a way for the community to test and give feedback on all the exciting things we have lined up for the...