home
products
contribute
download
documentation
forum
Home
Forums
New posts
Search forums
What's new
New posts
All posts
Latest activity
Members
Registered members
Current visitors
Donate
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Contact us
Close Menu
Forums
General Forums
Newcomers Forum
Can't browse network share on new build
Contact us
RSS
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Octavius" data-source="post: 1277628" data-attributes="member: 166486"><p>[USER=48495]@morpheus_xx[/USER], You're right I hadn't noticed that page on the Wiki, I was assuming that it would run in the context of the logged on user.</p><p></p><p>However, I had noticed the setting for network credentials and tried entering the logged in user's details, which didn't make a difference. I'll try again to double check that I've entered it all correctly.</p><p></p><p>What I did notice is that after entering the credentials, the next time I navigate to that setting in the MP2 interface it shows the username and password fields as blank. Is this just how the dialog box works, or does it indicate that the details haven't been saved?</p><p></p><p>Also, the MP2 (single seat) machine and the remote fileserver are part of the same domain. I've tried entering the credentials as <username> and <domain>\<username> without any luck.</p></blockquote><p></p>
[QUOTE="Octavius, post: 1277628, member: 166486"] [USER=48495]@morpheus_xx[/USER], You're right I hadn't noticed that page on the Wiki, I was assuming that it would run in the context of the logged on user. However, I had noticed the setting for network credentials and tried entering the logged in user's details, which didn't make a difference. I'll try again to double check that I've entered it all correctly. What I did notice is that after entering the credentials, the next time I navigate to that setting in the MP2 interface it shows the username and password fields as blank. Is this just how the dialog box works, or does it indicate that the details haven't been saved? Also, the MP2 (single seat) machine and the remote fileserver are part of the same domain. I've tried entering the credentials as <username> and <domain>\<username> without any luck. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
General Forums
Newcomers Forum
Can't browse network share on new build
Contact us
RSS
Top
Bottom