Reply to thread

Message

<blockquote data-quote="neilk" data-source="post: 427301" data-attributes="member: 52703">I posted this origionally in the My Music section of MediaPortal 1 and got no response. Possibly that was the incorrect forum, so I'm reposting under improvement suggestions, to see if anything can be done about this--------------------------------------------------------------------------------Hi there I would like to find out whether the following is possible to implement in MP music settings in the GUI - being able to select the Default Audio Renderer used for My Music?This is possible for Movies, DVD and TV, why not for Music?Let me state the reason for requesting this. I used to run XP, and was able to output audio through Analogue &amp; SPDIF at the same time . Since I upgraded to Vista, I am limited to either of the two for Music . When I send the audio stream to another Hi-Fi with speakers in my entertainment area, it requires analogue signal, and I have to start MP Config (closing MP), select Analogue device, close MP Config &amp; reopen MP.I would prefer to set this through Music settings in the GUI, so I dont have to close and open MP.Thank you to all the Devs for the time spent on this wonderful product RegardsNeil</blockquote>

[QUOTE="neilk, post: 427301, member: 52703"] I posted this origionally in the My Music section of MediaPortal 1 and got no response. Possibly that was the incorrect forum, so I'm reposting under improvement suggestions, to see if anything can be done about this -------------------------------------------------------------------------------- Hi there I would like to find out whether the following is possible to implement in MP music settings in the GUI - being able to select the Default Audio Renderer used for My Music? This is possible for Movies, DVD and TV, why not for Music? Let me state the reason for requesting this. I used to run XP, and was able to output audio through Analogue & SPDIF at the same time . Since I upgraded to Vista, I am limited to either of the two for Music . When I send the audio stream to another Hi-Fi with speakers in my entertainment area, it requires analogue signal, and I have to start MP Config (closing MP), select Analogue device, close MP Config & reopen MP. I would prefer to set this through Music settings in the GUI, so I dont have to close and open MP. Thank you to all the Devs for the time spent on this wonderful product Regards Neil [/QUOTE]

Verification