Reply to thread

Message

<blockquote data-quote="RobNCD" data-source="post: 761285" data-attributes="member: 114005">Windows Xp3 with all fixes2&nbsp; WinTV-HVR 1600 HDTV CardsMediaPortal 1.2.0 Beta ver 1.1.3I am having trouble getting my channels scanned into my QAM tuner.&nbsp; When I go through all the different versions of QAM and scan, the tuner will stop at the right frequencies and change from No Signal (the indicator goes to High Signal Quality) and stays there for a few seconds then says Nothing FoundIt continues on from there until it is done.&nbsp; When I go to the channels mappings there are only about 6 stations that have shown up. (those are the OTA ones).&nbsp; I am using Mediacom Cable service.&nbsp; For some reason all the normal Digital Channels dont show up, so... I cant map those to the cards.If I use the WinTV ver7 that came with the cards ALL the Digital Channels show up along with the OTA Channels.&nbsp; There are close to a hundred listed and working.&nbsp; Using the WinTV I can watch all the channels listed.&nbsp; Is there some reason that WinTV would work while MediaPortal wont.&nbsp; Is there&nbsp; a setting that can be turned on within MediaPortal so that ALL channels picked up in the scan would show so that I could test and then add to the mapping?&nbsp; Also, within MediaPortal I dont show ANY encrypted channels.(which doesnt matter to me, but seems strange)Any help would be greatly appreciated.</blockquote>

[QUOTE="RobNCD, post: 761285, member: 114005"] Windows Xp3 with all fixes 2 WinTV-HVR 1600 HDTV Cards MediaPortal 1.2.0 Beta ver 1.1.3 I am having trouble getting my channels scanned into my QAM tuner. When I go through all the different versions of QAM and scan, the tuner will stop at the right frequencies and change from No Signal (the indicator goes to High Signal Quality) and stays there for a few seconds then says Nothing Found It continues on from there until it is done. When I go to the channels mappings there are only about 6 stations that have shown up. (those are the OTA ones). I am using Mediacom Cable service. For some reason all the normal Digital Channels dont show up, so... I cant map those to the cards. If I use the WinTV ver7 that came with the cards ALL the Digital Channels show up along with the OTA Channels. There are close to a hundred listed and working. Using the WinTV I can watch all the channels listed. Is there some reason that WinTV would work while MediaPortal wont. Is there a setting that can be turned on within MediaPortal so that ALL channels picked up in the scan would show so that I could test and then add to the mapping? Also, within MediaPortal I dont show ANY encrypted channels.(which doesnt matter to me, but seems strange) Any help would be greatly appreciated. [/QUOTE]

Verification