Hi,
I have just installed MediaPortal 1.6.0
And only DiSEqC options are:
- None
- SimpleA, SimpleB
- Level1AA, Level1AB, Level1BA, Level1BB
This means to me that users who use DiSEqC switch with more than 4 lnb's are not able to use MediaPortal software.
1. Is this true or is it still possible with "plugin" to enable >4 lnb support?
It seems to me that >4 lnb support is the same as 4 or less support.
2. Will this support be implemeted in the near future?
I have also motorized dish and I have used position 01, 02, 03, 04, 05 to save satellites in the motor.
Moteck 2100A
Position 01 (E0 31 6B 01) = 13.0E
Position 02 (E0 31 6B 02) = 16.0E
Position 03 (E0 31 6B 01) = 19.2E
Position 04 (E0 31 6B 01) = 23.5E
Position 05 (E0 31 6B 01) = 28.2E
At this moment I am using DVBLogic software with RAW DiSEqC commands to move dish from position 01 to, 02.....
3. Is it possible to use RAW DiSEqC commands with MediaPortal?
4. If I use "Store position" button under DiSEqC Motor tab will this only store position in MediaPortal software or also in the motor?
I have just installed MediaPortal 1.6.0
And only DiSEqC options are:
- None
- SimpleA, SimpleB
- Level1AA, Level1AB, Level1BA, Level1BB
This means to me that users who use DiSEqC switch with more than 4 lnb's are not able to use MediaPortal software.
1. Is this true or is it still possible with "plugin" to enable >4 lnb support?
It seems to me that >4 lnb support is the same as 4 or less support.
2. Will this support be implemeted in the near future?
I have also motorized dish and I have used position 01, 02, 03, 04, 05 to save satellites in the motor.
Moteck 2100A
Position 01 (E0 31 6B 01) = 13.0E
Position 02 (E0 31 6B 02) = 16.0E
Position 03 (E0 31 6B 01) = 19.2E
Position 04 (E0 31 6B 01) = 23.5E
Position 05 (E0 31 6B 01) = 28.2E
At this moment I am using DVBLogic software with RAW DiSEqC commands to move dish from position 01 to, 02.....
3. Is it possible to use RAW DiSEqC commands with MediaPortal?
4. If I use "Store position" button under DiSEqC Motor tab will this only store position in MediaPortal software or also in the motor?