I wanted to try the new DiSEqC motor support. I did not find any instructions how to set it up, so this is what I did:
1. I have Skystar2 and for moving my dish I use SS2DiSEqC.exe. So with this I pointed the dish to Hispasat 30w.
2. In Scanning, LNB setup dialog of the TV server console I checked LNB#1, keep DiSEqC at none, and change the satellite to Hispasat.
3. I scan for channels.
4. Then I go to DiSEqC motor tab, check DiSEqC motor enabled.
5. Select the Hispasat satellite. The signal quality indicator is active.
6. I store the position as 1.
Now I am not sure, what to do next. So I tried this:
7. Move my dish to a new satellite with SS2DiSEqC.exe. For example Intelsat 907 27.5W.
8. Change the satellite from Hispasat (set in point 5) to Intelsat 907. Signal quality indicator is active.
9. I store the position as 2.
10. I test if the TV server moves the dish: change Intelsat to Hispasat and click Goto. I get message: Satellite moving to position:1, but nothing happens. The dish does not move.
What am I doing wrong?
I have Skystar2 with 4.4.0 drivers (MiBi modified). SS2DiSEqC.exe is moving my dish without any problems. So are AltDVB and DVBDream.
Thanks
Tomas
1. I have Skystar2 and for moving my dish I use SS2DiSEqC.exe. So with this I pointed the dish to Hispasat 30w.
2. In Scanning, LNB setup dialog of the TV server console I checked LNB#1, keep DiSEqC at none, and change the satellite to Hispasat.
3. I scan for channels.
4. Then I go to DiSEqC motor tab, check DiSEqC motor enabled.
5. Select the Hispasat satellite. The signal quality indicator is active.
6. I store the position as 1.
Now I am not sure, what to do next. So I tried this:
7. Move my dish to a new satellite with SS2DiSEqC.exe. For example Intelsat 907 27.5W.
8. Change the satellite from Hispasat (set in point 5) to Intelsat 907. Signal quality indicator is active.
9. I store the position as 2.
10. I test if the TV server moves the dish: change Intelsat to Hispasat and click Goto. I get message: Satellite moving to position:1, but nothing happens. The dish does not move.
What am I doing wrong?
I have Skystar2 with 4.4.0 drivers (MiBi modified). SS2DiSEqC.exe is moving my dish without any problems. So are AltDVB and DVBDream.
Thanks
Tomas