Reply to thread

Message

<blockquote data-quote="mm1352000" data-source="post: 917469" data-attributes="member: 82144">I think you may have misunderstood a little.DiSEqC is supported - we can control switches and motors.USALs is not supported.&nbsp;Yes, MediaPortal can even do it.I suggest you have a read of the wiki to help you see what is possible.--&gt;<a href="http://wiki.team-mediaportal.com/1_MEDIAPORTAL_1/141_Configuration/TV-Server_Configuration/02_TV_Servers/DiSEqC_Motor_Control" target="_blank">link</a>&lt;--&nbsp;You can do it all in MP.1. Go to the &quot;DiSEqC motor&quot; tab.2. Position the dish using the available controls (no need to use other software or go up to the roof).3. Click &quot;store position&quot;.4. Go to the &quot;scanning&quot; tab and scan.5. Repeat steps 1..4 for all satellites.&nbsp;DiSEqC 1.0 and 1.2 are supported.When you scan the channels, MP remembers where the dish should be in order to tune the channels later.&nbsp;I think it should be, but I don't have a motor.You have up/down/left/right controls to drive the motor, and a signal meter to tell you when it signal is locked. That should be enough.&nbsp;We are adding support for USALs (and hopefully unicable).Not sure how long it will take, but I don't think as long as a year - at least I hope not.</blockquote>

[QUOTE="mm1352000, post: 917469, member: 82144"] I think you may have misunderstood a little. DiSEqC is supported - we can control switches and motors. USALs is not supported. Yes, MediaPortal can even do it. I suggest you have a read of the wiki to help you see what is possible. -->[URL='http://wiki.team-mediaportal.com/1_MEDIAPORTAL_1/141_Configuration/TV-Server_Configuration/02_TV_Servers/DiSEqC_Motor_Control']link[/URL]<-- You can do it all in MP. 1. Go to the "DiSEqC motor" tab. 2. Position the dish using the available controls (no need to use other software or go up to the roof). 3. Click "store position". 4. Go to the "scanning" tab and scan. 5. Repeat steps 1..4 for all satellites. DiSEqC 1.0 and 1.2 are supported. When you scan the channels, MP remembers where the dish should be in order to tune the channels later. I think it should be, but I don't have a motor. You have up/down/left/right controls to drive the motor, and a signal meter to tell you when it signal is locked. That should be enough. We are adding support for USALs (and hopefully unicable). Not sure how long it will take, but I don't think as long as a year - at least I hope not. [/QUOTE]

Verification