United States of America
Our main Cisco router decided to shit itself (this is what i was told). Downtime was limited to 15 minutes or so so most of you probably didn't even notice it so i have no idea why i'm posting this.
:sorry:
:sorry:
Forum Downtime - 10-23-2006 (1 Viewer)
- Thread starter luke
- Start date
It's not pretty when a router (or any kind of equipment) decides to shit itself! 
lol
Users who are viewing this thread
Similar threads
Many thanks for the answer.
So far I've used Logitech's Harmony hub. This allows you to control all components (including the media portal). I have now contacted the Sofabaton hotline. It should also work here like with the Harmony. Unfortunately, not all of the IR codes are correct. You can also learn commands here. But that doesn't...
Many thanks for the answer.
So far I've used Logitech's Harmony hub. This allows you to control all components (including the...
I don't have a complicated A/V system - a Sony A8H TV, Yamaha receiver, and a HTPC on which I run most media through MediaPortal. I...
- Sticky
thanks
thanks
We are proud to present MediaPortal 2.5
MediaPortal 2.5 is a full-blown media center software that addresses most common user...
MP1
MP2
Epg does not open at the last watched channel + epg grab stuck if not manually deleted first
DE
Having used MP1 since 15 years, these epg related problems occuring after a fresh install stumble me.
Needed to change a system hdd and decided it was time for a clean install anyway. Other hardware (C2D, 8 Gb ram, no tv cards - IP only) unchanged. Was running an earlier Win10 version with MP 1.24 which had been updated for years...
Having used MP1 since 15 years, these epg related problems occuring after a fresh install stumble me.
Needed to change a system...
Having used MP1 since 15 years, these epg related problems occuring after a fresh install stumble me.
Needed to change a system...
MP1
MP2
TVService locks up or fails to restart on resuming from sleep, and crashes when grabbing EPG
DE
Good catch. (y)
When the OS encounters a bad disk block during a read or a write, it repeats the operation many many times to see if the operation will succeed. I recollect seeing the value of 100 times (but that may not be accurate). The OS does this for each block. If there are many defective blocks, the system slows down due to...
Good catch. (y)
When the OS encounters a bad disk block during a read or a write, it repeats the operation many many times to see...
Hello folks,
I recently upgraded from Win7 to Win10, and have had some problems with MediaPortal, the main problem was my TVServer...
Good job, nice release as usual (y)
Good job, nice release as usual (y)
We are proud to present MediaPortal 2.4
MediaPortal 2.4 is a full-blown media center software that addresses most common user...