Hide framerate? (1 Viewer)
- Thread starter dootgoop
- Start date
Users who are viewing this thread
Similar threads
My knowledge of programming is limited, but the logic in this seems to confirm what I thought, thank you.
My knowledge of programming is limited, but the logic in this seems to confirm what I thought, thank you.
Good evening,
Does anybody know the mouse position (Ypos coordinate) below which the topbar activates. I seem to remember there...
I need to try MadVR, I hope my Intel NAC can manage it.
I need to try MadVR, I hope my Intel NAC can manage it.
Remember PAL DVDs of US movies and TV Shows, and how they were converted to 25 fps thus introducing a "smurf lite" pitch on the...
When my AVR bit the dust recently I took the opportunity to upgrade my projector to an LS11000 to gain 4K. Install went fine until I switched to my HTPC which is my primary source. When I switch to the HTPC the screen goes blank for a long time and then I have sound, no picture, and in the lower left hand corner:
"Source: HDMI 1
Not...
When my AVR bit the dust recently I took the opportunity to upgrade my projector to an LS11000 to gain 4K. Install went fine until...
When my AVR bit the dust recently I took the opportunity to upgrade my projector to an LS11000 to gain 4K. Install went fine until...
Nice finding! (y)(y)(y)
Adapted to new DWHD and PVHD ;)
Position is in front of category bar ;)
Nice finding! (y)(y)(y)
Adapted to new DWHD and PVHD ;)
Position is in front of category bar ;)
This thread is intended for skin authors, plus those advanced users who have learnt skin programming and have customised the skins...
Yes. I've just this minute found the cause of the problem; though I haven't found the exact line of configuration that caused it.
I am using a centrally configured system, meaning that some configuration files are stored centrally and are not overridden when installing new versions. It would seem that 1.31 had a change in...
Yes. I've just this minute found the cause of the problem; though I haven't found the exact line of configuration that caused it...
Since I installed 1.31 .wtv files display in the top left-hand quadrant of the screen instead of the whole screen.
Is this a known...