In advanced mode, you will have this button (marked in red):
Click on it to open attachment popup.
Upload image(s) and close attachment popup window.
Now place the cursor at the position in message body where you want to place image and press the same button again.
You get a dropdown with your attachments. Select the one you want to embed in message.
I don't organise my media in the way that you do, so I don't know whether MediaPortal provides the capability that you want. All that I can suggest is that you read this page in the MP Wiki and experiment to see if it will merge the separate folders to give you a unified view of the media.
-- from CyberSimian in the UK
I don't organise my media in the way that you do, so I don't know whether MediaPortal provides the capability that you want. All...
Hi i have a collection of 9208(Still growing on a daily basis)) music videos(ripped in m2ts format from blu-rays) which are stored...
I was installing/upgrading x64 over x86.
These 2 problems did not occur when installing/upgrading x86 over x86.
All is good. Now running 1.35 x86 with no problem.
Thank you
I was installing/upgrading x64 over x86.
These 2 problems did not occur when installing/upgrading x86 over x86.
All is good. Now...
Good day,
2 problems after upgrading to 1.34 from 1.33:
1- To avoid error message TuningParameters not found when starting...
I have just installed Windscribe but it is blocking access to my TV Server. I get the following message "Please specify the IP address or Host Name of the Master TV Service". I have a single seat build running the latest X64 version of MP1. Can anyone point me to a solution please? It's probably a really obvious one.....
Cheers
Fangio
I have just installed Windscribe but it is blocking access to my TV Server. I get the following message "Please specify the IP...
I have just installed Windscribe but it is blocking access to my TV Server. I get the following message "Please specify the IP...
Result, it works on the two PC's we use for watching TV :D I've not lost anything by the looks of it either, all channels etc still setup.
Just my office PC won't connect, which I only use for testing things anyway (I tried updating that this morning as well), but I'll uninstall and install fresh on that.
PS. Exported all settings...
Result, it works on the two PC's we use for watching TV :D I've not lost anything by the looks of it either, all channels etc still...
I tried to install MP 1.35 this morning, but I couldn't get any further with the installation on the TV server, see error message...