- December 2, 2008
- 71
- 2
- Home Country
-
Spain
(ignore this message)
(ignore) (1 Viewer)
- Thread starter trepamuros
- Start date
Users who are viewing this thread
Similar threads
Today my PVR disk died, taking with it a load of old recorded TV programmes. I swapped in a spare drive but I see that MP2 still thinks the old recordings exist. I expected the metadata for the recordings to be in same folder as the PVR but apparently not.
How do I make MP2 forget about these old recordings?
Needless to say, I tried...
Today my PVR disk died, taking with it a load of old recorded TV programmes. I swapped in a spare drive but I see that MP2 still...
Today my PVR disk died, taking with it a load of old recorded TV programmes. I swapped in a spare drive but I see that MP2 still...
According to Wikipedia, Windows only uses code pages other than UTF-8 to support legacy (mostly 32 bit) applications and supports two code pages in addition to UTF-8 (OEM and ANSI). According to Microsoft, UTF-8 has been the preferred character set since 2019. If TV Server (or its import routine) were using UTF-8, then umlauts...
According to Wikipedia, Windows only uses code pages other than UTF-8 to support legacy (mostly 32 bit) applications and supports...
Because I have around 200 TV channels and more than a dozen groups, I tried to import the TV channel groups from an old export.xml...
I was installing/upgrading x64 over x86.
These 2 problems did not occur when installing/upgrading x86 over x86.
All is good. Now running 1.35 x86 with no problem.
Thank you
I was installing/upgrading x64 over x86.
These 2 problems did not occur when installing/upgrading x86 over x86.
All is good. Now...
Good day,
2 problems after upgrading to 1.34 from 1.33:
1- To avoid error message TuningParameters not found when starting...
Apologies Pablik. My bad. I neglected to run WMI Manager and check Properties as you advised. Sure enough, it produced this error:
I tried to run winmgmt /resetrepository, but there were conflicts with running services. So I stopped those services (Malwarebytes & IP Helper), then stopped the winmgmt service. I was then able to run...
Apologies Pablik. My bad. I neglected to run WMI Manager and check Properties as you advised. Sure enough, it produced this error...
Hi,
Was using v1.33 without issue. Then started receiving error message "Unknown error occurred" when trying to watch TV. Upgraded...
I was installing/upgrading x64 over x86.
These 2 problems did not occur when installing/upgrading x86 over x86.
All is good. Now running 1.35 x86 with no problem.
Thank you
I was installing/upgrading x64 over x86.
These 2 problems did not occur when installing/upgrading x86 over x86.
All is good. Now...
Good day,
Same 2 installation problem as last version.
2 problems after upgrading to 1.35 from 1.34:
1- To avoid error message...