Reply to thread

Message

<blockquote data-quote="pfilippone" data-source="post: 1300775" data-attributes="member: 171757">I've been successfully using MediaPortal1 and TV Server 1.17 on Win7 for years, using first a HDHomerun tuner, when that died, a Hauppauge WinTV DualHD ATSC USB tuner. Recently the Hauppauge tuner died on me (still shows up, but all channels show 'no signal'), so I went and purchased a new Hauppauge WinTV DualHD ATSC tuner.The problem is, the device shows up OK as two tuners as expected, it works fine with the Hauppauge WinTV 10 software, but with TV Server, I get nothing but black on all channels.&nbsp; This is in TV Server config &gt; channels &gt; Preview channel, and in Media Portal.&nbsp; In TV Server config, I was able to scan channels OK on both tuners. So it seems the tuner is getting recognized and channels scan works, but not getting any video/audio.Although the old and new Hauppauge tuners look identical, the new one must have vastly newer firmware, as it required WinTV 10 software and driver combo, whereas the old tuner used WinTV 8 software and driver combo.I've since installed Win10 Pro and MediaPortal 1.36 from scratch with no success. I tried both x86 and x64 versions. Same issue as mentioned above. Logs attached.Thank you!</blockquote>

[QUOTE="pfilippone, post: 1300775, member: 171757"] I've been successfully using MediaPortal1 and TV Server 1.17 on Win7 for years, using first a HDHomerun tuner, when that died, a Hauppauge WinTV DualHD ATSC USB tuner. Recently the Hauppauge tuner died on me (still shows up, but all channels show 'no signal'), so I went and purchased a new Hauppauge WinTV DualHD ATSC tuner. The problem is, the device shows up OK as two tuners as expected, it works fine with the Hauppauge WinTV 10 software, but with TV Server, I get nothing but black on all channels. This is in TV Server config > channels > Preview channel, and in Media Portal. In TV Server config, I was able to scan channels OK on both tuners. So it seems the tuner is getting recognized and channels scan works, but not getting any video/audio. Although the old and new Hauppauge tuners look identical, the new one must have vastly newer firmware, as it required WinTV 10 software and driver combo, whereas the old tuner used WinTV 8 software and driver combo. I've since installed Win10 Pro and MediaPortal 1.36 from scratch with no success. I tried both x86 and x64 versions. Same issue as mentioned above. Logs attached. Thank you! [/QUOTE]

Verification