Reply to thread

Message

<blockquote data-quote="Coop" data-source="post: 1146134" data-attributes="member: 153912">I run Windows 7 Professional with Service Pack 1, Intel Pentium 2.8 GHz, and 3.00 GB RAM and 32 bit operating system.I am using a Direct TV Digital Satellite Box. It is connected to a Hauppauge WinTV HVR-1600 NTSC/ATSC/AQM Combo (743xx) Card.I am using MediaPortal 2.I have installed Direct X 9, Microsoft .NET Framework 4.5.2, Microsoft Visual Basic C+++ 2013When I start the MediaPortal 2 Setup TV program it recognizes the two parts of the card- ATSC Hauppauge WinTV 418 BDA tuner and Analog Hauppauge WinTV 418 tuner. The card is connected to the Digital Satellite Box by an S-Video cable. The S-Video out on the box is set to channel 3. When I scan for channels with the Analog part of the card (I have added S-video channels with the “Add S-Video channels tab selected) I receive a message Unable to scan. “The graph building. Mostly your card is not supported by TVServer. Plesase create a report in our forum.” If I scan for channels under the ATSC Hauppauge WinTV 418 BDA Tuner, no channels are found but there is no tab for setting the S-Video option nor an option for Satellite in the Tuning mode. I have tried scanning with the ATSC Digital Terrestrial option, Digital Cable option and Clear QAM cable option. With the latter I tried all the QAM tuning frequencies options. Under the general tab I have set both SDT/VCT and Analog to 120 seconds as suggested.Enclosed is the Server Error log file I could findDo you have any suggestions?</blockquote>

[QUOTE="Coop, post: 1146134, member: 153912"] I run Windows 7 Professional with Service Pack 1, Intel Pentium 2.8 GHz, and 3.00 GB RAM and 32 bit operating system. I am using a Direct TV Digital Satellite Box. It is connected to a Hauppauge WinTV HVR-1600 NTSC/ATSC/AQM Combo (743xx) Card.I am using MediaPortal 2. I have installed Direct X 9, Microsoft .NET Framework 4.5.2, Microsoft Visual Basic C+++ 2013 When I start the MediaPortal 2 Setup TV program it recognizes the two parts of the card- ATSC Hauppauge WinTV 418 BDA tuner and Analog Hauppauge WinTV 418 tuner. The card is connected to the Digital Satellite Box by an S-Video cable. The S-Video out on the box is set to channel 3. When I scan for channels with the Analog part of the card (I have added S-video channels with the “Add S-Video channels tab selected) I receive a message Unable to scan. [U]“The graph building. Mostly your card is not supported by TVServer. Plesase create a report in our forum.”[/U] If I scan for channels under the ATSC Hauppauge WinTV 418 BDA Tuner, no channels are found but there is no tab for setting the S-Video option nor an option for Satellite in the Tuning mode. I have tried scanning with the ATSC Digital Terrestrial option, Digital Cable option and Clear QAM cable option. With the latter I tried all the QAM tuning frequencies options. Under the general tab I have set both SDT/VCT and Analog to 120 seconds as suggested. Enclosed is the Server Error log file I could find Do you have any suggestions? [/QUOTE]

Verification