Microsoft Remote Control doesn't work on MP (1 Viewer)
- Thread starter isotoper
- Start date
England
Does a keyboards up\down work, if so uninstall ehome receiver under device manager, unplug receiver, reboot and then plug back in, should reinstall itself.
If changing batteries, leave them out for 20 minutes prior to fitting new.
Users who are viewing this thread
Similar threads
Are the media/video folders on the Mint host?
Are the media/video folders on the Mint host?
I've used Mediaportal for years on a Windows Host with restricted online-access.
Lately I reinstalled...
Thank you for this tip! I'm moving MP TV Server to a new machine. I installed the 64-bit version and most of the MP firewall rules were set to Public. I couldn't connect to the new TV Server from my old single-seat installation running 32-bit until I changed all MP-related firewall rules on the new machine to Private. Before I did...
Thank you for this tip! I'm moving MP TV Server to a new machine. I installed the 64-bit version and most of the MP firewall...
Server and client on modern uptodate Windows 11 desktop. Software is Server and Client version x86 1.38.003
Remote client on...
4.5 is really old. I'm not sure 4.5.5 even is a version that actually existed. You should be able to install .NET Framework 4.8.0 on Windows 7 SP1
4.5 is really old. I'm not sure 4.5.5 even is a version that actually existed. You should be able to install .NET Framework 4.8.0...
My TV PC is more a cast-off on older hardware (a 'Quiet PC' i5 4690, 16GB ram, 2xSSD 1xHDD, system graphics), mainly as a cheap way...
I have also had this problem in the past. There are two components to this problem:
Your internet router is pinging the HTPC at regular intervals in order to see if the HTPC is still present on the network.
The network adapter in the HTPC has "Wake on Lan" enabled. So at the end of a recording, the HTPC transitions from away mode to...
I have also had this problem in the past. There are two components to this problem:
Your internet router is pinging the HTPC at...
Nachdem ich mp 1.38 neu installiert habe klappt soweit alles wie früher. Ein Problem besteht aber und das ist Standby nach einer...
MP1
MP2
1.38
Running TVService as "NT Service\TVService" or "Local Service" not working anymore since Windows September 2025 updates
DE
Reading through your code, I can see it's more than a couple steps above my paygrade. :cry:
Reading through your code, I can see it's more than a couple steps above my paygrade. :cry:
I used to run the TVService under the "NT Service\TVService" account to follow least privileges principal (not exposing my whole...
