MP gets stuck at "starting plugins" (1 Viewer)

[doogle]

After running MP101 since release, all is great. Until a day or so ago I noticed that sometimes MP doesn't start up properly and hangs at "Starting Plugins". I've used debug mode and attached logs. I had to end the mediaportal process by using End Process in task manager in order to get the logs.

 

[superforever]

I have the same problem sometime after wake up from standby.

I think the only solutions is to find a way to close MP before standby. I tried MP standby tools but having another problem, like it will try to standby the PC for me and MP will also try to standby the PC for me at the same time. So after wake up loaded MP interface it will gone into standby again immediately.

 

[doogle]

I always close MP and let TVservice control going to standby. The only plugins enabled are powerscheduler and xmltv.

 

[etheesdad]

Have you checked the plug ins from the client?

 

[moab]

It does this if you are out of space on your hard disk.
Verify you have free space.

 

[doogle]

plenty of free space. only way to clear this is to restart pc. what do you mean check plugins in client?

 

[etheesdad]

plenty of free space. only way to clear this is to restart pc. what do you mean check plugins in client?

In the MP Client config, go to Plugins, and see if any of them are causing the issue is what I mean. You dont state that you have specifically identified soleley the TVserver plugins as at fault, and from the way your post reads this seems to be the only aspect you're considering...?

 

[superforever]

I have similar problem after disabled Power Scheduler the problem gone.

But without Power Scheduler I cannot get the PC to standby by itself after recording.

 

[doogle]

I disabled Powerscheduler in client and server and then re-enables. Seems to have resolved the issue. Not sure why.

 

[superforever]

I disabled Powerscheduler in client and server and then re-enables. Seems to have resolved the issue. Not sure why.

Tried result is the same.

Any better solutions to solve out this standby/resume problem.

I have tried difference combination of programs to get standby to work properly. But none of them works 100%.

Like:
1. Stuck at plug-in loading screen.
2. Resume from standby and gone back to standby immediately.
3. Sometime will not standby after recording, etc etc....

Any suggestions?