I have the MP-GUI slightly scaled down in my setup and the position of the OSD shifted a bit upwards as you can see in the attached ScreenCalibration xml.
Now when I start MP and watch a recorded TV the up-shifted OSD position is not respected when I first press the Y-button to show the OSD.
Only after the second (or sometimes third) showing of the OSD the position is correct.
After that the OSD-position is correct for the rest of the MP-session.
But the error re-occurs always at a new MP-session.
Steps to reproduce:
Kind regards
Roger
Now when I start MP and watch a recorded TV the up-shifted OSD position is not respected when I first press the Y-button to show the OSD.
Only after the second (or sometimes third) showing of the OSD the position is correct.
After that the OSD-position is correct for the rest of the MP-session.
But the error re-occurs always at a new MP-session.
Steps to reproduce:
- Set GUI scaling like in the attached ScreenCalibration xml
- Start MP
- Start a recorded TV-File (or any other file with an OSD)
- Press "Y" to show OSD --> OSD position too low (as in unclibrated GUI)
- Press "Y" to hide OSD and again to show OSD again --> OSD position in correct position
Kind regards
Roger