Palmbutler RF remote (1 Viewer)
- Thread starter Coolrat
- Start date
Denmark
Users who are viewing this thread
Similar threads
Thank you Cybersymian, that solution works perfectly. Thanks for the prompt reply and solution.
Thank you Cybersymian, that solution works perfectly. Thanks for the prompt reply and solution.
I recently upgraded to Mediaportal 1.33 x64 version. Everything works great, except when I drop out to Windows and want to go back...
Ran into this problem following an otherwise sucessful upgrade from MP 1.34 x64 to MP 1.35 x64 the CEC Remote plugin which I use just to control volume and standby, will no longer put my devices (TV & AVR) to sleep when the HTPC is put in standby. Also when I wake up the HTPC MP closes or crashes (not sure which) as per the example in...
Ran into this problem following an otherwise sucessful upgrade from MP 1.34 x64 to MP 1.35 x64 the CEC Remote plugin which I use...
Ran into this problem following an otherwise sucessful upgrade from MP 1.34 x64 to MP 1.35 x64 the CEC Remote plugin which I use...
It is possible to have both MP1 and MP2 installed on the same drive (I have a test partition with just such an arrangement). However...
The TV Server parts of MP1 and MP2 start when the system boots, and TV Server runs all of the time, even when it is not recording and live TV is not being viewed. If both TV Servers were active, they...
It is possible to have both MP1 and MP2 installed on the same drive (I have a test partition with just such an arrangement)...
Help Please.
Yesterday upon switch-on, I had this issue with MP2:
When I clicked on the [REC] icon in the following Image...
Nice finding! (y)(y)(y)
Adapted to new DWHD and PVHD ;)
Position is in front of category bar ;)
Nice finding! (y)(y)(y)
Adapted to new DWHD and PVHD ;)
Position is in front of category bar ;)
This thread is intended for skin authors, plus those advanced users who have learnt skin programming and have customised the skins...
Apologies Pablik. My bad. I neglected to run WMI Manager and check Properties as you advised. Sure enough, it produced this error:
I tried to run winmgmt /resetrepository, but there were conflicts with running services. So I stopped those services (Malwarebytes & IP Helper), then stopped the winmgmt service. I was then able to run...
Apologies Pablik. My bad. I neglected to run WMI Manager and check Properties as you advised. Sure enough, it produced this error...
Hi,
Was using v1.33 without issue. Then started receiving error message "Unknown error occurred" when trying to watch TV. Upgraded...