- September 14, 2006
- 89
- 0
- 44
Ok, first off, I didnt know where to put this thread so I took a chance.
I use a VGA connection to my LCD flatscreen tv and a DVI-D to my Sanyo Z2 projector. Of cause the TV is primary. Thing is, whenever I would like to watch a movie, I do it on the projector. And all other time it is in standby. Problem is that it is not recognized by windows (nvidia) if its in standby, I always have to quit MP and then go to the nvidia controlpanel, I just have to open the controlpanel because it sends signals everywhere and checks everything automatically, so I dont have to actually change anything. Then I have configured a button on the remote to switch display.
However, the problem is that I would like this detection to be made inside MP or by an external hotkey on the remote without having to reboot or load the nvidia controlpanel.
Any ideas?
I use a VGA connection to my LCD flatscreen tv and a DVI-D to my Sanyo Z2 projector. Of cause the TV is primary. Thing is, whenever I would like to watch a movie, I do it on the projector. And all other time it is in standby. Problem is that it is not recognized by windows (nvidia) if its in standby, I always have to quit MP and then go to the nvidia controlpanel, I just have to open the controlpanel because it sends signals everywhere and checks everything automatically, so I dont have to actually change anything. Then I have configured a button on the remote to switch display.
However, the problem is that I would like this detection to be made inside MP or by an external hotkey on the remote without having to reboot or load the nvidia controlpanel.
Any ideas?