Reply to thread

Message

<blockquote data-quote="htpcoz" data-source="post: 123116" data-attributes="member: 13987">Hi,I've just upgraded to a new SVN, and consequently the 02 feb version of the mce replacement test. I am installing the SVN version.When I go into configuration for the plugin, it complains about not finding the mceir.dll file. This file is not in the directory with the plugin, but I can find it in the driver installation directory. If I take the file from there, and put it into the same directory as the plugin (plugin/process) it still complains about the file.If I find an older version of the mceir.dll (older replacement version, not the original MS version) and put that in the directory with the plugin, the configuration will now start. However when I try to do a test blast from the configuration, nothing happens and I see the following in the log;2007-02-03 06:58:54.421875 [Info.][Config Main]: MCEReplacement: BlastIR() Unable to find an entry point named 'MceIrSetBlasterSpeed' in DLL 'MceIr.dll'.2007-02-03 06:58:54.421875 [ERROR][Config Main]: MCEReplacement: BlastIR() Unable to find an entry point named 'MceIrSetBlasterSpeed' in DLL 'MceIr.dll'.So it would seem that the new plugin depends on the set blaster speed entry point, however the old versions of the mceir.dll do not support this. If I try to use the new mceir.dll that ships (and installs in c:\program files\mce replacement driver) with the 02 feb test release, it appears that the file is not recognised by the plugin. The file is now considerably smaller, the new file is 20K the old one is over 80K.Is there a problem with the new mceir.dll, or do I have to put it somewhere special for the plugin to recognise it. I've tried to register the dll, but it doesn't appear to support registration.Any ideas?</blockquote>

[QUOTE="htpcoz, post: 123116, member: 13987"] Hi, I've just upgraded to a new SVN, and consequently the 02 feb version of the mce replacement test. I am installing the SVN version. When I go into configuration for the plugin, it complains about not finding the mceir.dll file. This file is not in the directory with the plugin, but I can find it in the driver installation directory. If I take the file from there, and put it into the same directory as the plugin (plugin/process) it still complains about the file. If I find an older version of the mceir.dll (older replacement version, not the original MS version) and put that in the directory with the plugin, the configuration will now start. However when I try to do a test blast from the configuration, nothing happens and I see the following in the log; 2007-02-03 06:58:54.421875 [Info.][Config Main]: MCEReplacement: BlastIR() Unable to find an entry point named 'MceIrSetBlasterSpeed' in DLL 'MceIr.dll'. 2007-02-03 06:58:54.421875 [ERROR][Config Main]: MCEReplacement: BlastIR() Unable to find an entry point named 'MceIrSetBlasterSpeed' in DLL 'MceIr.dll'. So it would seem that the new plugin depends on the set blaster speed entry point, however the old versions of the mceir.dll do not support this. If I try to use the new mceir.dll that ships (and installs in c:\program files\mce replacement driver) with the 02 feb test release, it appears that the file is not recognised by the plugin. The file is now considerably smaller, the new file is 20K the old one is over 80K. Is there a problem with the new mceir.dll, or do I have to put it somewhere special for the plugin to recognise it. I've tried to register the dll, but it doesn't appear to support registration. Any ideas? [/QUOTE]

Verification