Problems with MyBlaster (1 Viewer)

[maisoft]

Hi !
I have some problem with myBlaster. Teaching to myBlaster does'nt work because the myBlaster config doesn't wait my press on button 0, 1 and 2.
In other words button from 4 to 9 works fine but 0,1 and 2 are immediately "larned" by MyBlaster without pressing any button on the remote !!!!

Can anyone help me ???

Thanks!

 

[een_mq]

Hi and Welcome

I have noticed that too when I was having the blaster learn my STB remote IR signal...

IR interference is actually intefering with your signal learing... Fluorescent light, even sunlight might be culprit...

Try this, close the curtain and turn off the lights...
And then highlight 1 and press learn again...
If it fails, keep trying until you get the 10 seconds prompt to enter the signal...
If it still doesn't work, you are still getting interference from outside...

I was having the same thing, but in my case the last few numbers were the one playing up...

Good luck

 

[maisoft]

I will try later but I have no lights near the receiver, even sunlight ..
Maybe the hd and power led of the HTPC ???