Remote not working (using IRtrans) (1 Viewer)

[flexi]

Hi MP is running perfectly now, but I can't get my Remote working.

I am using an old Sony Remote and IRtrans. This setup is working fine. However I was not able so far to use this remote to control MP.

The log shows the following:

[Info.][5]: IRTrans: Command Start --------------------------------------------
[Info.][5]: IRTrans: Client = 0
[Info.][5]: IRTrans: Status = STATUS_RECEIVE
[Info.][5]: IRTrans: Remote = mediaportal
[Info.][5]: IRTrans: Command Num. = 0
[Info.][5]: IRTrans: Command = ok
[Info.][5]: IRTrans: Data = S101001110000
[Info.][5]: IRTrans: Command End ----------------------------------------------
[Info.][5]: IRTrans: Command Start --------------------------------------------
[Info.][5]: IRTrans: Client = 0
[Info.][5]: IRTrans: Status = STATUS_RECEIVE
[Info.][5]: IRTrans: Remote = mediaportal
[Info.][5]: IRTrans: Command Num. = 0
[Info.][5]: IRTrans: Command = down
[Info.][5]: IRTrans: Data = S010011010000
[Info.][5]: IRTrans: Command End ----------------------------------------------
[Info.][5]: IRTrans: Command Start --------------------------------------------
[Info.][5]: IRTrans: Client = 0
[Info.][5]: IRTrans: Status = STATUS_RECEIVE
[Info.][5]: IRTrans: Remote = mediaportal
[Info.][5]: IRTrans: Command Num. = 0
[Info.][5]: IRTrans: Command = up
[Info.][5]: IRTrans: Data = S100011010000
[Info.][5]: IRTrans: Command End ----------------------------------------------

For the device-mapping I have copied the MCE-Keyboard template.

Problem: Remote is not working MP. The log is the only proof I have, that MP is listening to IRtrans.

Any idea?

Thanks!

 

[flexi]

Problem solved.
There was some still unknown problem with the device-mapping xml.
I just started with a fresh MCE template and then it worked.