RSTP stream output is OK, but on wrong interface. (1 Viewer)

[kiklhorn]

Please add option for manual choice of the network card for stream output.
I wish somewhere in code some as
RtspStreaming.StreamSetup(ipAddessOfUserChoicedNetworkCard)

Only if you must ask for what I wish this thing, you read next words. Thanks.

TV Server: tvengine3-01-27-2007--01-12h--Rev12766
Windows Version: XPSP2+latest patch
CPU Type: AMD-FX60
Memory: 2GB
Motherboard: Asus A8N-VM-CSM
Motherboard Chipset: nforce 6150
Motherboard Bios: latest
Video Card: 6150
1. TV Card: AirStar2 (B2C2 chipset)
1. TV Card Type: DVB-T

1. network card:1394, by dhcp, currently not assigned
2. network card:Technisat DVB-PC TV Star PCI, no dhcp, address 192.168.238.238/24 - this is my DVBT card based on B2C2 chipset - works OK
3. network card:Nvidia Nforce Net controller, no dhcp, address 192.168.4.10/24 - this card used for connection to other word
4. network card:Windows Mobile-based Device #7, dhcp + autoconfig, 169.254.2.2/24 - this card is dynamicaly created by MS activeSync 4.2+ for my WM5 devices

RSTP stream output is OK, but on wrong interface.

first on "4.th" network card
27-01-2007 16:50:22 Stream serveretup stream server for ip:169.254.2.2

if I disabled it and restart tv service - then apears on "2nd" card

27-01-2007 17:00:43 Stream serveretup stream server for ip:192.168.238.238
27-01-2007 18:14:06 Stream server: add timeshift mpeg-2 transport stream stream1 filename:H:\recordings\timeshifting\live1.ts.tsbuffer
27-01-2007 18:14:06 Stream server: url for stream is rtsp://192.168.238.238/stream1

If I disabled this card too, thes no input evidently (this is my dvb-t B2C2 based tv card) and no stream output...

Then i disabling, enabling cards, restarting PC, onetime all seems ok, but then I put my WM5 ipaq in cradle, new network interface was created and after last restart stream server putting output to this address.

...I want see in "streaming server.Log" next line:
someday sometime Stream serveretup stream server for ip:192.168.4.10

 

[Rhys.Goodwin]

Do you mean?

Go to TVServer setup at the top of the tree Select TV Servers. In the right hand pane select the server and click edit. Make sure that the IP Address is correct. e.g. the IP address that you would normally use to connect to the TV Server PC remotly.

Also I found that you need to reset this settings after every uninstall/re-install of tvserver. I only had to 2 network interfaces, one of them was my SkyStar 2 DVBS. Since I don't use this card with internet I disabled TCP/IP on by unticking TCP/IP on the network card properties. Now it always defaults to the interface/ listen address that I want. Either way you can just change this in the TVEngine3 Setup.