Reply to thread

Message

<blockquote data-quote="patrick" data-source="post: 248973" data-attributes="member: 12502">hmmm...Looking at your log it looks like you have several tuner cards.Lets start with just the analog card and digitalcable lineup.I am going to assume this is you setup:-Coax in for analog channels and an external input (like s-video) for the digital channelsSince, like you said, your channel mapping is already screwed up:[code]Channel WMPN (actually WMAH) was found as 4 WMPN (actually WMAH) in EPG mapping databaseChannel WMAUDT (WMAU-DT) was found as 0 WMAUDT (WMAU-DT) in EPG mapping database[/code]Can you clear your channels and then run the auto-tune/scan again for the Analog ONLY card(s)?(Don't rename them, they should be just a number)Then in the plugin config check Allow matching by channel number only (cannot remember the exact words atm)?It looks like you have a couple of digital channels in this lineup also. If you have these coming in via s-video or something then you can add these manually or allow the plugin to auto-add digital channels.(If auto-adding you may have to assign the channels to a card after they are added)Save the log after this so you can post it if there are problems.After this is all setup correctly then come back and do the same for OTA ATSC and add your local lineup.I can ramble at times so if this is not clear just ask.Let us know how it goes.HTH,patrick</blockquote>

[QUOTE="patrick, post: 248973, member: 12502"] hmmm... Looking at your log it looks like you have several tuner cards. Lets start with just the analog card and digitalcable lineup. I am going to assume this is you setup: -Coax in for analog channels and an external input (like s-video) for the digital channels Since, like you said, your channel mapping is already screwed up: [code] Channel WMPN (actually WMAH) was found as 4 WMPN (actually WMAH) in EPG mapping database Channel WMAUDT (WMAU-DT) was found as 0 WMAUDT (WMAU-DT) in EPG mapping database [/code] Can you clear your channels and then run the auto-tune/scan again for the Analog ONLY card(s)? (Don't rename them, they should be just a number) Then in the plugin config check Allow matching by channel number only (cannot remember the exact words atm)? It looks like you have a couple of digital channels in this lineup also. If you have these coming in via s-video or something then you can add these manually or allow the plugin to auto-add digital channels. (If auto-adding you may have to assign the channels to a card after they are added) Save the log after this so you can post it if there are problems. After this is all setup correctly then come back and do the same for OTA ATSC and add your local lineup. I can ramble at times so if this is not clear just ask. Let us know how it goes. HTH, patrick [/QUOTE]

Verification