Reply to thread

Message

<blockquote data-quote="Quake505" data-source="post: 581823" data-attributes="member: 92046">Hi All,Just a quick update, it looks like I have a problem with my card, I have send a e-mail to TBS asking if it is a known issue with the driver but I'm guessing it's not and the card will need to be replaced.The problem I have is with LNB port 1 with will not pickup all the channels on 28.2, for example it will not pickup the BBC red button streams on TP 12441 V, but if I use the same coax on LNB port 2 it does without any problems.LNB port 1 will pick up over 200 channels where port 2 will pick up over 700 using the same cable, LNB and dish.Here is my findings so far: -Installaion of the card was fine on WinXP, installed the card, selected the corrected driver for my OS, rebooted the PC, opened TVsetup and the two ports were seen as two different cards, selected card b (port 2) selected the correct Sat and done a channel scan, added the channels to the all channel group, started media portal client and watch the channels.I have only selected 28.2 with a single LNB, ie Fixed Dish with one LNB, no&nbsp; DiSEqC or Rotor.The signal streagth is good, and very clear, the channels I have selected look very clear with sharp edges and deep colours when compaired to my Technomate.Its just a shame I have a problem with port 1.</blockquote>

[QUOTE="Quake505, post: 581823, member: 92046"] Hi All, Just a quick update, it looks like I have a problem with my card, I have send a e-mail to TBS asking if it is a known issue with the driver but I'm guessing it's not and the card will need to be replaced. The problem I have is with LNB port 1 with will not pickup all the channels on 28.2, for example it will not pickup the BBC red button streams on TP 12441 V, but if I use the same coax on LNB port 2 it does without any problems. LNB port 1 will pick up over 200 channels where port 2 will pick up over 700 using the same cable, LNB and dish. Here is my findings so far: - Installaion of the card was fine on WinXP, installed the card, selected the corrected driver for my OS, rebooted the PC, opened TVsetup and the two ports were seen as two different cards, selected card b (port 2) selected the correct Sat and done a channel scan, added the channels to the all channel group, started media portal client and watch the channels. I have only selected 28.2 with a single LNB, ie Fixed Dish with one LNB, no DiSEqC or Rotor. The signal streagth is good, and very clear, the channels I have selected look very clear with sharp edges and deep colours when compaired to my Technomate. Its just a shame I have a problem with port 1. [/QUOTE]

Verification