Reply to thread

Message

<blockquote data-quote="mm1352000" data-source="post: 1094235" data-attributes="member: 82144">Yes, it is strange, and no unfortunately I don't have an answer.If the failure were closer to the initial tuning I might suspect that we had to tell the driver to send the command at a different time in the tune process, or wait a bit longer after sending the command... or something like that. But 30+ seconds in... I have no explanation for that.No, I don't think the driver is buggy because it seems to be able to cause the switch to change port successfully. It isn't clear that the driver is the cause of the problem that happens after that, so I don't want to start pointing fingers. Either way it would be definitely be worthwhile to contact TBS support and see what they can do for you.I have a fair amount of head knowledge about DiSEqC, but only limited experience in practice. The one EMP Centauri 9x8 multiswitch I've owned has worked with every tuner I've tried it with... though effectively that is only a 2 port DiSEqC switch with a cascaded 22 kHz switch.Updated patch attached. This one sends the command twice every time you tune.Regards,mm</blockquote>

[QUOTE="mm1352000, post: 1094235, member: 82144"] Yes, it is strange, and no unfortunately I don't have an answer. If the failure were closer to the initial tuning I might suspect that we had to tell the driver to send the command at a different time in the tune process, or wait a bit longer after sending the command... or something like that. But 30+ seconds in... I have no explanation for that. No, I don't think the driver is buggy because it seems to be able to cause the switch to change port successfully. It isn't clear that the driver is the cause of the problem that happens after that, so I don't want to start pointing fingers. Either way it would be definitely be worthwhile to contact TBS support and see what they can do for you. I have a fair amount of head knowledge about DiSEqC, but only limited experience in practice. The one EMP Centauri 9x8 multiswitch I've owned has worked with every tuner I've tried it with... though effectively that is only a 2 port DiSEqC switch with a cascaded 22 kHz switch. Updated patch attached. This one sends the command twice every time you tune. Regards, mm [/QUOTE]

Verification