Reply to thread

Message

<blockquote data-quote="tvo81" data-source="post: 1283739" data-attributes="member: 167536">Update: I tried another clean install of MP 1.27, added TbsCIapi.dll, bearing in mind your points above.I scan 23.5E (Astra B), again only getting a handful of channels. I should point out that I always usually scan like this, thus not using the advanced tuning options. Until very recently, I would get all channels on 23.5E. When I had my dish installed back in November, the company placed a diseqc switch so that I can also watch 28.2E &amp; 19.2E. When I scan those two, it works fine. When I use DVBViewer, scanning for channels works as it should.When you say &quot;tuning parameters your try to scan are missing&quot;, should I be doing something prior to scanning? I did update the satellite list. I'm not sure why it finds 1.9°E BulgariaSat 1.xml to be missing, I'm not scanning for this satellite. I had a look in the folder C:\ProgramData\Team MediaPortal\MediaPortal TV Server\TuningParameters\dvbs and 158 files were updated when I refreshed the satellite list.Finally I also tried scanning just one transponder, and this time I did get all channels on that transponder. But after when I scanned for all of 23.5E, the same issue as before.Signal quality should be good, especially as it works with DVBViewer and because I could watch scrambled channels on 23.5E until 2 weeks ago.I'm really at a loss here, any feedback is much appreciated. Logs attached.</blockquote>

[QUOTE="tvo81, post: 1283739, member: 167536"] Update: I tried another clean install of MP 1.27, added TbsCIapi.dll, bearing in mind your points above. I scan 23.5E (Astra B), again only getting a handful of channels. I should point out that I always usually scan like this, thus not using the advanced tuning options. Until very recently, I would get all channels on 23.5E. When I had my dish installed back in November, the company placed a diseqc switch so that I can also watch 28.2E & 19.2E. When I scan those two, it works fine. When I use DVBViewer, scanning for channels works as it should. When you say "tuning parameters your try to scan are missing", should I be doing something prior to scanning? I did update the satellite list. I'm not sure why it finds 1.9°E BulgariaSat 1.xml to be missing, I'm not scanning for this satellite. I had a look in the folder C:\ProgramData\Team MediaPortal\MediaPortal TV Server\TuningParameters\dvbs and 158 files were updated when I refreshed the satellite list. Finally I also tried scanning just one transponder, and this time I did get all channels on that transponder. But after when I scanned for all of 23.5E, the same issue as before. Signal quality should be good, especially as it works with DVBViewer and because I could watch scrambled channels on 23.5E until 2 weeks ago. I'm really at a loss here, any feedback is much appreciated. Logs attached. [/QUOTE]

Verification