Reply to thread

Message

<blockquote data-quote="bluebear" data-source="post: 821363" data-attributes="member: 82697">Hi mm1352000! I finally got to make some logs for you. This is with a 6922 and all logs from tvserver. Seems to be alot of errors related to cam, but also errors when starting up. Made a run in test channels in the tvserver config. It appears that every 60th or so tuning have no signal. I have seen this in my day to day use also, but more frequent than what the test channels would imply. And it seems to work for 4-5 sec than picture freeze. Tuning details says signal level is 0. If I change channel I have picture again, but it can distort or freeze again later on. However if I stop timeshiftbuffer and start again I do not experience these stops. I´m not sure if this is related, I have seen it before your patch. Although back then I could not use my diseqC. Writing it here to see if I´m the only one seeing this. All in all it works ok, just a few small glitches. Hope my logs help. Cheers, B.</blockquote>

[QUOTE="bluebear, post: 821363, member: 82697"] Hi mm1352000! I finally got to make some logs for you. This is with a 6922 and all logs from tvserver. Seems to be alot of errors related to cam, but also errors when starting up. Made a run in test channels in the tvserver config. It appears that every 60th or so tuning have no signal. I have seen this in my day to day use also, but more frequent than what the test channels would imply. And it seems to work for 4-5 sec than picture freeze. Tuning details says signal level is 0. If I change channel I have picture again, but it can distort or freeze again later on. However if I stop timeshiftbuffer and start again I do not experience these stops. I´m not sure if this is related, I have seen it before your patch. Although back then I could not use my diseqC. Writing it here to see if I´m the only one seeing this. All in all it works ok, just a few small glitches. Hope my logs help. Cheers, B. [/QUOTE]

Verification