Technotrend budget and resume from standby (S3) (1 Viewer)

[AlexPlas]

MediaPortal Version: 0.2.2.0
MediaPortal Skin: BlueTwo Wide
Windows Version: Windows XP SP2
CPU Type: Athlon64 3500+
HDD: WD SATA 250G
Memory: 1G DDR2 667MHz
Motherboard: ASRock ALiveSATA2-GLAN
Motherboard Chipset: VIA K8T890+VT8237A
Video Card: Asus nVidia 7300LE
Video Card Driver: ForceWare 93.71
1. TV Card: TechnoTrend Budget C-1500 + CI
1. TV Card Type: DVB-C
1. TV Card Driver: 4.4.10.18 (10/26/2006)
MPEG2 Video Codec: NVIDIA Video Decoder
MPEG2 Audio Codec: NVIDIA Audio Decoder
Satelite/CableTV Provider: Volia Premium TV, Kiev, Ukraine
HTPC Case: Termaltake Tenor
Remote: Microsoft MCE Remote
TV: LG 32LC3R
TV - HTPC Connection: Sub-D

I have one problem with MediaPortal.

When my HTPC had resumed from S3 state, and I try to watch TV - error is occurred - "Unable to connect MPG2 pin". After restarting MediaPortal I can watch TV without problems. I have tested it with scrambled and free to air channels, with and without CAM module, in full screen and windowed mode with same results.

Now I see only one difference in TV initialization process on MP start and S3 resume: in vmr9.log vmr9:InitializeDevice() call exists on MP start and does not exists on S3 resume.

I’m a software developer and I can to compile MediaPortal and test it on my hardware. Any suggestion will be useful.

 

[rtv]

You'll find all inits and relevant parts in MediaPortal.cs (parts may be in d3dapp.cs)

 

[pmcguire]

Hi,

This seems to be a major issue with technotrend cards and the rubbish drivers, I get very often the unable to connect mpg pin and also the unable to creat graph error.

Now I have noticed that if I use PVR-Scheduler and set it to hibernate only I have better luck. I then can standby, wake up and view TV but only once. I will then have to restart the PC if I wish to use standby again

Technotrend have to sort this crap out I am afraid.