Reply to thread

Message

<blockquote data-quote="alexirion" data-source="post: 701114" data-attributes="member: 101977">Re: AW: Re: TeVii S480 Dual DVB-S2 HDTV PCIe supported?Hi!I installed 1.1.2.45 again and changed the delay to 90 seconds. I sucessfully recorded a movie with the driver and also did some chanal zapping without a crash. Then I started refreshing the EPG and started the on/off test, that wakes the computer up and puts it to sleep with an interval of 180s. After a few minutes I had the BSOD again, it appeared at 22:35:09 (when the computer crashes the lcd display with the time freezes), but the crashdump (010811-14437-01.dmp) was saved at 22:48, when I restarted the computer. It was directly crashing again after reboot (010811-34578-01.dmp from 22:52). Please also find the attached logs:2011-01-08 22:34:56.881835 [DVB EPG timer(11)]: dvb:grab epg...2011-01-08 22:48:34.500000 [(5)]: TV service: StartingSo, it crashed right away during grabbing?Regards,--AlexWhat happens if you:- use 1.1.2.45- leave EPG grabber enabled- change the &quot;delay in seconds before TV Server detects cards&quot; setting in TV Server configuration (General section) to 90 seconds</blockquote>[/QUOTE]

[QUOTE="alexirion, post: 701114, member: 101977"] [b]Re: AW: Re: TeVii S480 Dual DVB-S2 HDTV PCIe supported?[/b] Hi! I installed 1.1.2.45 again and changed the delay to 90 seconds. I sucessfully recorded a movie with the driver and also did some chanal zapping without a crash. Then I started refreshing the EPG and started the on/off test, that wakes the computer up and puts it to sleep with an interval of 180s. After a few minutes I had the BSOD again, it appeared at 22:35:09 (when the computer crashes the lcd display with the time freezes), but the crashdump (010811-14437-01.dmp) was saved at 22:48, when I restarted the computer. It was directly crashing again after reboot (010811-34578-01.dmp from 22:52). Please also find the attached logs: 2011-01-08 22:34:56.881835 [DVB EPG timer(11)]: dvb:grab epg... 2011-01-08 22:48:34.500000 [(5)]: TV service: Starting So, it crashed right away during grabbing? Regards, --Alex What happens if you: - use 1.1.2.45 - leave EPG grabber enabled - change the "delay in seconds before TV Server detects cards" setting in TV Server configuration (General section) to 90 seconds[/QUOTE] [/QUOTE]

Verification