Netherlands
Area: Media Portal Program
TV Card Model: FloppyDTV, priority : 2
TV Card Type: DVB C
TV Card Driver: 4.1.0 BDA
TV Card Model: Hauppauge PVR 150, priority: 1
TV Card Type: Analog
TV Card Driver: ?
Synopsis:
I have a configuration where most TV channels are available on both tuners. When I select a TV channel that's available on the analog Hauppauge card only (sorry, for testing purposes I tried "Tel Sell" Embarassed ), and I try to switch back to a channel which is available on both tuners ("Nederland 2" in this case), MP stays tuned on the Tel Sell channel.
Checking the channel setting for "Nederland2": in the tvdatabase iChannelnr is set to 10402, which is the service ID for the dvb-C version of this channel. Because 10402 is not a valid analog channel, MP refuses to switch back. Why doesn't MP just tune in to the frequency which is stored in the database? Does channelnr take precedence above frequency? Strange indeed.
Perhaps more important: I would expect MP to change channels to the DVB version of Nederland2, because the FloppyDTV has a higher priority than the Hauppauge tuner.
In short:
I guess MP should:
1) check which TV card has highest priority for this channel
2) tune in to the frequency (stored in Channel Table) in stead of tuning in to the channelnumber.
According to the status, MP thinks it HAS switched channels. When I stop "my TV" and switch it back on, only then has the channel switch taken place.
Please advise.
TV Card Model: FloppyDTV, priority : 2
TV Card Type: DVB C
TV Card Driver: 4.1.0 BDA
TV Card Model: Hauppauge PVR 150, priority: 1
TV Card Type: Analog
TV Card Driver: ?
Synopsis:
I have a configuration where most TV channels are available on both tuners. When I select a TV channel that's available on the analog Hauppauge card only (sorry, for testing purposes I tried "Tel Sell" Embarassed ), and I try to switch back to a channel which is available on both tuners ("Nederland 2" in this case), MP stays tuned on the Tel Sell channel.
Checking the channel setting for "Nederland2": in the tvdatabase iChannelnr is set to 10402, which is the service ID for the dvb-C version of this channel. Because 10402 is not a valid analog channel, MP refuses to switch back. Why doesn't MP just tune in to the frequency which is stored in the database? Does channelnr take precedence above frequency? Strange indeed.
Perhaps more important: I would expect MP to change channels to the DVB version of Nederland2, because the FloppyDTV has a higher priority than the Hauppauge tuner.
In short:
I guess MP should:
1) check which TV card has highest priority for this channel
2) tune in to the frequency (stored in Channel Table) in stead of tuning in to the channelnumber.
According to the status, MP thinks it HAS switched channels. When I stop "my TV" and switch it back on, only then has the channel switch taken place.
Please advise.