I've got the same problem, when I open "TV" it goes to the tv menu and the tv is started in the corner. But when I click on it to go to fullscreen mode I just get sound but no tv. If I try to go back then MP locks up completely, and I have to terminate it through the taskmanager.
Apologies Pablik. My bad. I neglected to run WMI Manager and check Properties as you advised. Sure enough, it produced this error:
I tried to run winmgmt /resetrepository, but there were conflicts with running services. So I stopped those services (Malwarebytes & IP Helper), then stopped the winmgmt service. I was then able to run...
Apologies Pablik. My bad. I neglected to run WMI Manager and check Properties as you advised. Sure enough, it produced this error...
Hi,
Was using v1.33 without issue. Then started receiving error message "Unknown error occurred" when trying to watch TV. Upgraded...
Ran into this problem following an otherwise sucessful upgrade from MP 1.34 x64 to MP 1.35 x64 the CEC Remote plugin which I use just to control volume and standby, will no longer put my devices (TV & AVR) to sleep when the HTPC is put in standby. Also when I wake up the HTPC MP closes or crashes (not sure which) as per the example in...
Ran into this problem following an otherwise sucessful upgrade from MP 1.34 x64 to MP 1.35 x64 the CEC Remote plugin which I use...
Ran into this problem following an otherwise sucessful upgrade from MP 1.34 x64 to MP 1.35 x64 the CEC Remote plugin which I use...