Reply to thread

Message

<blockquote data-quote="toricred" data-source="post: 814561" data-attributes="member: 24463">First of all I am not using IR, but I understand what you mean. 1.&nbsp; You first need to go into the settings for your DirecTV receiver and set up a static ip address on the same netowork as your server.&nbsp; Obviously you need to have your DTV receiver plugged into your network.2.&nbsp; Next install IRSS (IR Server Suite) on your server.3.&nbsp; Open TV Server Configuration and turn on the TV3 Blaster Plugin for IR Server plugin.&nbsp; 4.&nbsp; After this you canxpand the Plugins menu item and go to the TV3 Blaster Plugin for IR Server sub menu.5.&nbsp; Click on the STB Setup button.&nbsp; 6.&nbsp; There is a tab for each TV card installed in the system.&nbsp; Select the tab for the card you are using to capture from the DTV Receiver.7.&nbsp; Select PreChange from the commands window and &quot;Run Program&quot; from the drop-down below the commands window.&nbsp; Click on Set and point the Program box to the dtvtune app I attached earlier.&nbsp; The parameters should be: -channel %2 -ip DTVReceiver'sip.&nbsp; All checkboxes should be clear except for No Window.8.&nbsp; Click OK to close all the windows and open MP to try it out.I may have forgotten a step, but I believe that is it.</blockquote>

[QUOTE="toricred, post: 814561, member: 24463"] First of all I am not using IR, but I understand what you mean. 1. You first need to go into the settings for your DirecTV receiver and set up a static ip address on the same netowork as your server. Obviously you need to have your DTV receiver plugged into your network. 2. Next install IRSS (IR Server Suite) on your server. 3. Open TV Server Configuration and turn on the TV3 Blaster Plugin for IR Server plugin. 4. After this you canxpand the Plugins menu item and go to the TV3 Blaster Plugin for IR Server sub menu. 5. Click on the STB Setup button. 6. There is a tab for each TV card installed in the system. Select the tab for the card you are using to capture from the DTV Receiver. 7. Select PreChange from the commands window and "Run Program" from the drop-down below the commands window. Click on Set and point the Program box to the dtvtune app I attached earlier. The parameters should be: -channel %2 -ip DTVReceiver'sip. All checkboxes should be clear except for No Window. 8. Click OK to close all the windows and open MP to try it out. I may have forgotten a step, but I believe that is it. [/QUOTE]

Verification