Reply to thread

Message

<blockquote data-quote="jameson_uk" data-source="post: 723005" data-attributes="member: 11220">Not sure if it cut off before the end but there is no groupmap table in there which I partly what I wanted to look at.&nbsp;&nbsp; Also this did make me realise that you have some analogue stuff but you did say channel about DVB provider so I guess the issue is not realted to analogue.&nbsp;&nbsp; I have tried a few different tests&nbsp; but I am struggling to find the time to look at this in depth (may be tomorrow) and I just can not get the channel up button on my RC6 remote (I am assuming you are using the standard MCE setting and not some other remote software?)A lot of code in MP is leftover from years ago and has been changed so&nbsp; many times it is pretty messy.&nbsp;&nbsp; This makes sense and when I get 10&nbsp; minutes I will just check and as you say it is likely this can be ripped&nbsp; out alltogether.What would be helpful is if you could figure out where in the code radio channels are being picked up.</blockquote>

[QUOTE="jameson_uk, post: 723005, member: 11220"] Not sure if it cut off before the end but there is no groupmap table in there which I partly what I wanted to look at. Also this did make me realise that you have some analogue stuff but you did say channel about DVB provider so I guess the issue is not realted to analogue. I have tried a few different tests but I am struggling to find the time to look at this in depth (may be tomorrow) and I just can not get the channel up button on my RC6 remote (I am assuming you are using the standard MCE setting and not some other remote software?) A lot of code in MP is leftover from years ago and has been changed so many times it is pretty messy. This makes sense and when I get 10 minutes I will just check and as you say it is likely this can be ripped out alltogether. What would be helpful is if you could figure out where in the code radio channels are being picked up. [/QUOTE]

Verification