Hello,
need Your help for my MP with serveral TV-Cards. One of them is my old Hauppauge WinTV analog TV-Card. Because there is no analog TV signal I'd like to use only the composite input for a video camera at our front door.
Until now I used this TV card parallel to MP with a Motion detection SW. Because of serveral bluescreens I would like to integrate the composite signal into MP. Therefor I enabled the Hauppauge Card in MP TVServer config an tried to find a possiblity to add the composite signal to the channel list.
So there are there questions I found no answer yet?
1. How to add this composite input signal to the MP channels?
2. Do I need to install a video encoder? I found a few threads about installing analog TV Cards to MP. Most of the refer to this page Supported_TVCard_Analog_Software_Encoding - MediaPortal Manual Documentation but there is no content???
On other threads I found a hint to a MCE software encoder from Hauppage with version 1.x. On hauppauge website there is now only the V2.0 Version and that version does not support WINTV PCI
3. Is there allready a motion detection plugin for MP ?
Thanks
Ramu
need Your help for my MP with serveral TV-Cards. One of them is my old Hauppauge WinTV analog TV-Card. Because there is no analog TV signal I'd like to use only the composite input for a video camera at our front door.
Until now I used this TV card parallel to MP with a Motion detection SW. Because of serveral bluescreens I would like to integrate the composite signal into MP. Therefor I enabled the Hauppauge Card in MP TVServer config an tried to find a possiblity to add the composite signal to the channel list.
So there are there questions I found no answer yet?
1. How to add this composite input signal to the MP channels?
2. Do I need to install a video encoder? I found a few threads about installing analog TV Cards to MP. Most of the refer to this page Supported_TVCard_Analog_Software_Encoding - MediaPortal Manual Documentation but there is no content???
On other threads I found a hint to a MCE software encoder from Hauppage with version 1.x. On hauppauge website there is now only the V2.0 Version and that version does not support WINTV PCI
3. Is there allready a motion detection plugin for MP ?
Thanks
Ramu