[no Bug] VirtualCloneDrive does not mount image - wrong parameters (1 Viewer)

[u28151]

Hi,

I tried mounting an ISO image with VitrualCloneDrive and I get an error message stating "Cannot mount....".
When running the command line extracted from MP log:
[2014-04-15 17:15:09,780] [Log ] [MPMain ] [INFO ] - Start process C:\Program Files (x86)\Elaborate Bytes\VirtualCloneDrive\Daemon.exe -mount , 0,"C:\Filmer\wilder-ganatomys09d01.iso"
I can see that there is a comma just after "-mount".
When running manually without the comma the image will mount successfully.
So the correct comand line would be:
C:\Program Files (x86)\Elaborate Bytes\VirtualCloneDrive>daemon -mount 0, "c:\filmer\wilder-ganatomys09d01.iso"

Running VirtualCloneDrive version 5.4.7.0 on MP 1.7 pre installade on a x64 Windows 8.1 OS.
Attached logs and screenshots.

Please tell me if further information is needed!

Best regards

Ulf

 

[u28151]

The same error occurs on 1.7 final. Maybe this post should be moved?

 

[u28151]

This is apparently fixed in 1.7.1 without being published as a bug nor mentioned in the change log.
Anyway, thank you for getting it working!

 

[HomeY]

This is apparently fixed in 1.7.1 without being published as a bug nor mentioned in the change log.
Anyway, thank you for getting it working!

Nope, there have been 0 changes on this in the 1.7.1 HotFix, so i assume it was a 'hiccup' in your installation

But good that you got it working!

 

[u28151]

Strange...
Thanks for input, most important is that the problem is gone and I can once again mount ISOs!

/U