Volume level (1 Viewer)
- Thread starter tvviewer
- Start date
There might be registry tricks available but there isnt anyway in MP to do this. It just records what the card send it.
Id suggest having a a look on the SHSPVR forums.
Id suggest having a a look on the SHSPVR forums.
I had a similiar problem to. I can only select "use default direct sound device" in the audio renderer properties of MP. If I chose NVIDIA direct sound, the volume was really low.
Users who are viewing this thread
Similar threads
MP1
MP2
1.38
Running TVService as "NT Service\TVService" or "Local Service" not working anymore since Windows September 2025 updates
DE
Reading through your code, I can see it's more than a couple steps above my paygrade. :cry:
Reading through your code, I can see it's more than a couple steps above my paygrade. :cry:
I used to run the TVService under the "NT Service\TVService" account to follow least privileges principal (not exposing my whole...
I currently have two Quatros running, one connect, one duo using OTA antennae, mostly UHF fringe area, mostly cat5 local network.
Hauppauge card retired long ago. I have also retired very early SD units, the Quatros seem to work much better than the older units.
Go to SD's support website and download and install the windows...
I currently have two Quatros running, one connect, one duo using OTA antennae, mostly UHF fringe area, mostly cat5 local network...
I am currently using a Hauppauge WinTV QuadHD PCIe card on MP1 (1.37) for DVB-T, but 2 of the tuners have died. Thinking about...
I haven't tested it.
I use MP1, but sometimes I try to help with MP2 :).
I haven't tested it.
I use MP1, but sometimes I try to help with MP2 :).
This happened immediately after my Windows 11 x64 monthly update for November. The update included also cumulative update to .NET...
Any other suggestions for this?
Any other suggestions for this?
I have Flirc and the Skip 1s remote sending volume +/- events. I prefer to rely on just the Windows volume control so in...
Can anyone tell me the step-by-step procedure for bringing up a second channel in pip mode? I can only do it sometimes, after many tries, and it’s not clear what I am doing that makes it work on those occasions when it does. Cannot find guidance on the site.
Thanks, N.
Again, if anyone knows how to do this, would be much...
Can anyone tell me the step-by-step procedure for bringing up a second channel in pip mode? I can only do it sometimes, after many...
Can anyone tell me the step-by-step procedure for bringing up a second channel in pip mode? I can only do it sometimes, after many...