Why does WebEPG start after every standby? (1 Viewer)

Juppe

Portal Pro
November 17, 2006
308
42
Home Country
Sweden Sweden
I have i little but annoying problem, the problem is that WebEPG start every time the computer wakes up from S3. I have both the TV-server and MP set to grap EPG at 12:00 and what I can see, the computer wakes upp at that time and grabs the EPG and all is fine, then the computer goes into S3 again, so that is working fine, but when I wake it up later in the day or it is woken up by a recording it starts to grab EPG again and do it OK this time to, so my question is, why is this happening? I can say that I have set MP to restart on wake up, if that can anything to do with it. The annoying part is that the EPG is not filled when I wake MP, because it is grabbing and filling it then.

Steps to reproduce it.

1. Set the WebEPG grabber in MP to run every day.
2. Set the Power Scheduler in TV-server to wake up at the same time as WebEPG to grab EPG.
3. Set so that MP is starting over on resume, dont know where to find this now.
4. Let the computer go into S3 and see so that it wakes up to grab EPG and then let it go into S3 again.
5. Wake it up manual and see if its grabbing the EPG again, which it not shall do.

Will try to upload logs later today when I'm at home.

Hope someone can take a look at this.

/Juppe
 

Users who are viewing this thread

Top Bottom