Reply to thread

Message

<blockquote data-quote="rsbrux" data-source="post: 857990" data-attributes="member: 49539"><a href="https://forum.team-mediaportal.com/members/micropolis.96567/" target="_blank">Micropolis</a>,Sorry, I should have RTFM before whining!&nbsp;Since #772 was posted long before the release of 0.5.0, I assume that this is already included. My problem is undoubtedly due to not setting the wait values discussed below. Your DHCP tip was also valuable. It reminded me to switch my HTPC (back) to a fixed IP address. I only wish I could remember why I put it on DHCP. Probably something to do with my UPnP client, which doesn't work right now anyway.&nbsp;Thanks for the tip! After looking at this section, I found the &quot;Expert Settings&quot; &quot;at startup wait ...&quot; and &quot;after resume wait ...&quot;, which will probably take care of the popup about the internet connection. I also enabled &quot;Force image refresh&quot;, which I hope will help with the image refresh issue I reported. &quot;Force refresh after system resume&quot; was already enabled (see attached).What puzzles me is that even after doing this, the tag below, which look as though it should correspond to the latter setting, is still set to &quot;no&quot;:[CODE]&nbsp; &nbsp; &lt;entry name=&quot;RefreshUpdateAfterResume&quot;&gt;no&lt;/entry&gt;[/CODE]Even after saving and closing Configuration.&nbsp;Am I misinterpreting this entry or is it not being saved properly?</blockquote>

[QUOTE="rsbrux, post: 857990, member: 49539"] [URL='https://forum.team-mediaportal.com/members/micropolis.96567/']Micropolis[/URL], Sorry, I should have RTFM before whining! Since #772 was posted long before the release of 0.5.0, I assume that this is already included. My problem is undoubtedly due to not setting the wait values discussed below. Your DHCP tip was also valuable. It reminded me to switch my HTPC (back) to a fixed IP address. I only wish I could remember why I put it on DHCP. Probably something to do with my UPnP client, which doesn't work right now anyway. Thanks for the tip! After looking at this section, I found the "Expert Settings" "at startup wait ..." and "after resume wait ...", which will probably take care of the popup about the internet connection. I also enabled "Force image refresh", which I hope will help with the image refresh issue I reported. "Force refresh after system resume" was already enabled (see attached). What puzzles me is that even after doing this, the tag below, which look as though it should correspond to the latter setting, is still set to "no": [CODE] <entry name="RefreshUpdateAfterResume">no</entry> [/CODE] Even after saving and closing Configuration. Am I misinterpreting this entry or is it not being saved properly? [/QUOTE]

Verification