MP 0.2.0.4 - skystar 2 (dvb-s) - diseq not working (1 Viewer)

[skr-home]

Hi,

during the last days i tried to setup MP on my brother's HTPC environment.

He is using a Technisat Skystar 2 (DVB-S) card with newest drivers. Via a multiswitch there are 2 LNBs (LNB1: Astra 19.2E, LNB2: Eutelsat/Hotbird 13E) connected.

When he use the DVBViewer everything works fine. In MP setup it was possible to run autotune with both LNBs and more then 1000 channels were found. So far so good, but in MyTV it isn't possible to switch between channels from Astra and Eutelsat/Hotbird. So something must be wrong with diseq support in MP. Diseq support for the skystar 2 should be available, or?

We already checked the diseq settings and compared it with DVBViewer. Level 1 A/A for LNB1 and Level 1 B/A for LNB2.

Thanks a lot

Sebastian

 

[skr-home]

Anyone out there?

I think my settings should be correct, or? During autotune the signal quality bar was changing, but the shown signal strength was always 0. On my own HTPC with FloppyDTV card the strength bar is normal.

At the moment i have no idea what could be worg.

Thanks for any help!

 

[rtv]

try to catch micheloe on the official irc channel - he might have a clue..